板牙工具 Threading Tool
• Threading Tool can be threaded manual making L.H. screw , is an essential tool for high pressure Tubing.
板牙工具可手动制作钢管的左旋螺纹，是超高压管件加工的必备工具。
• Design of the guide sleeve , ensure the concccentricity of processing.
设计有导向套，保证了加工的同心度。
TT6板牙工具
型号说明 Model description
板牙操作说明 Threading operation instruction
• Claming fixed block of coning tool（horizontal or vertical installation）.
把CT工具上的固定块固定（水平或者垂直安装）。
• Loosen the tighten gland nut , and remove the handle together.
把旋转螺母松开和手柄一起拿掉。
• The pipe cone inserts into the chuck outward , and lock the gland（As shown in the following figure）.
松开螺母，把钢管锥面朝外插进夹头里面锁紧螺母（如下图所示）。
• In the observation hole drops into the cutting oil , to maintain lubricating on blade teeth.
在板牙工具上的观察孔上滴进切削油，使牙刃上保持润滑。
• Hold the handle with both hands , the threading hole pressing to trap the cone end , in a counter clockwise rotating forcibly tools , turn back after each turn 1～2 rounds , chip cutting discharge , then turned into , according to the required length of the left-hand thread cutting out , finally inversion tools completely out.
双手握住手柄，把板牙孔压紧套住管锥端，逆时针用力转动工具， 每转动1～2转就要退转，使切削屑排出，再进转，根据所需长度把左旋螺纹切削出来，最后反转工具完全退出，板牙完成。
板牙和锥面尺寸 Threading Size and Cone
倒内圆锥工具 Reseating Tool
• Reseationg tools is used to repair old or damaged valve or equipment connector.
倒内圆锥工具用于维修旧的或是损坏的阀门或是连接件的内孔。
弯管器 Bending Tool
• Applicable to high pressure steel pipe , outer diameter 1/4" , 3/8" , 9/16".
适用于高压钢管外径1/4"、3/8"、9/16"。
